tc-red(8) - phpMan

RED(8) Linux RED(8)

NAME
red - Random Early Detection

SYNOPSIS
tc qdisc ... red limit bytes [ min bytes ] [ max bytes ] avpkt bytes [ burst packets ] [
ecn ] [ harddrop] [ bandwidth rate ] [ probability chance ] [ adaptive ]

DESCRIPTION
Random Early Detection is a classless qdisc which manages its queue size smartly. Regular
queues simply drop packets from the tail when they are full, which may not be the optimal
behaviour. RED also performs tail drop, but does so in a more gradual way.

Once the queue hits a certain average length, packets enqueued have a configurable chance
of being marked (which may mean dropped). This chance increases linearly up to a point
called the max average queue length, although the queue might get bigger.

This has a host of benefits over simple taildrop, while not being processor intensive. It
prevents synchronous retransmits after a burst in traffic, which cause further retrans-
mits, etc.

The goal is to have a small queue size, which is good for interactivity while not disturb-
ing TCP/IP traffic with too many sudden drops after a burst of traffic.

Depending on if ECN is configured, marking either means dropping or purely marking a
packet as overlimit.

ALGORITHM
The average queue size is used for determining the marking probability. This is calculated
using an Exponential Weighted Moving Average, which can be more or less sensitive to
bursts.

When the average queue size is below min bytes, no packet will ever be marked. When it
exceeds min, the probability of doing so climbs linearly up to probability, until the
average queue size hits max bytes. Because probability is normally not set to 100%, the
queue size might conceivably rise above max bytes, so the limit parameter is provided to
set a hard maximum for the size of the queue.

PARAMETERS
min Average queue size at which marking becomes a possibility. Defaults to max /3

max At this average queue size, the marking probability is maximal. Should be at least
twice min to prevent synchronous retransmits, higher for low min. Default to limit
/4

probability
Maximum probability for marking, specified as a floating point number from 0.0 to
1.0. Suggested values are 0.01 or 0.02 (1 or 2%, respectively). Default : 0.02

limit Hard limit on the real (not average) queue size in bytes. Further packets are
dropped. Should be set higher than max+burst. It is advised to set this a few times
higher than max.

burst Used for determining how fast the average queue size is influenced by the real
queue size. Larger values make the calculation more sluggish, allowing longer
bursts of traffic before marking starts. Real life experiments support the follow-
ing guideline: (min+min+max)/(3*avpkt).

avpkt Specified in bytes. Used with burst to determine the time constant for average
queue size calculations. 1000 is a good value.

bandwidth
This rate is used for calculating the average queue size after some idle time.
Should be set to the bandwidth of your interface. Does not mean that RED will shape
for you! Optional. Default : 10Mbit

ecn As mentioned before, RED can either 'mark' or 'drop'. Explicit Congestion Notifica-
tion allows RED to notify remote hosts that their rate exceeds the amount of band-
width available. Non-ECN capable hosts can only be notified by dropping a packet.
If this parameter is specified, packets which indicate that their hosts honor ECN
will only be marked and not dropped, unless the queue size hits limit bytes. Recom-
mended.

harddrop
If average flow queue size is above max bytes, this parameter forces a drop instead
of ecn marking.

adaptive
(Added in linux-3.3) Sets RED in adaptive mode as described in
http://icir.org/floyd/papers/adaptiveRed.pdf
Goal of Adaptive RED is to make 'probability' dynamic value between 1% and 50% to reach the target average queue :
(max - min) / 2

EXAMPLE
# tc qdisc add dev eth0 parent 1:1 handle 10: red
limit 400000 min 30000 max 90000 avpkt 1000
burst 55 ecn adaptive bandwidth 10Mbit